Engineering Analysis Capabilities
Thermal and Stress Analysis
Implicit/Explicit Dynamic Analysis
Fatigue/Fracture Mechanics
Kinematics
Dynamics/Rotodynamics
Buckling/Containment
Engines and Systems Performance
Acoustics and Noise Control
Heat Transfer and Cooling
CFD/Aero
Flow Systems Simulation
Combustion Systems
Fuel Systems and Fuel Technology
Thermal and Stress Analysis
- Steady-state and transient
- Non-linear contact, plasticity, buckling, creep, large deflection
- Classic hand calculations
- Isotropic, orthotropic, anisotropic, composite, hyperelastic materials
Implicit/Explicit Dynamic Analysis
- Implicit transient
- Explicit transient
- Bird strike
- Ballistics
- Fan blade containment
- Rollover assessment
- Inflation analysis
Fatigue/Fracture Mechanics
- Hand calculations
- Goodman assessment
- Airforce method
- LCF
- HCF
- Crack growth
- Residual life
Kinematics
- Assembly lines
- Actuation systems
- Externals separation
- Tooling clearances
Dynamics/Rotordynamics
- Drive systems
- Gearbox sizing
- Compressor drum response
- Linear and damped modal analysis
- Forced response analysis
- Power spectral density
- Harmonic analysis
Buckling/Containment
- Nacelle design
- Casing design
- Hand calculations, Eigenbuckling, and non-linear failure analyses
- Disk burst
Engine and Systems Performance
- Engine cycle modeling and analysis
- Engine performance methods development
- Steady state and transient engine data analysis
- Test cell correlation
- Engine test monitoring and data analysis
Acoustics and Noise Control
- Acoustic analysis and noise control
- Airborne and structureborne noise
- Far field noise predictions
- Duct and acoustic liner treatment
- Transmission losses
- Acoustic property calculations
Heat Transfer and Cooling
- SS and transient
- Conduction, convection, radiation analysis
- Active and passive cooling designs
- Film, impingement and transpiration cooling
CFD/Aero
- Compressible and supersonic flows
- Laminar and turbulent flows
- Flows with conjugate heat transfer
- Multiphase flows
- Engine installation and ventilation
- Combustion systems
- Turbomachinery design
Flow Systems Simulation
- SS and transient
- Fuel system simulation
- Air flow distribution and management
Combustion Systems
- Combustion design
- Low emissions design and analysis
- Heat Transfer and Cooling
Fuel Systems and Fuels Technology
- Evaluation fuel additives, contamination, lubricity
- Fuel specifications
- Fuels testing
- Engine eval. new fuels
- Fuel nozzle design and eval.
|
